Toshiba DK424I 用户手册
System & Station
Program 12 – System Assignments, Basic Timing
3-44
Strata DK Programming 5/00
Program 12 – System Assignments, Basic Timing
Processor Type:
DK14, DK40i, all RCTUs and BCUs
Program Type:
Station
Program 12 Overview
This program assigns system times for ring down, disconnecting calls, pause times, flash times,
auto attendant, DISA, Call Forward External, and DNIS and DTMF receiving decoding.
auto attendant, DISA, Call Forward External, and DNIS and DTMF receiving decoding.
Code 1: Standard Telephone Ring Down Timer
This feature is available for Release 4.0 and higher. Code 1 assigns the number of seconds that a
Hotline or Emergency standard telephone waits after going off-hook before automatically ringing
a preassigned directory number. If a valid feature access code or [DN] is dialed prior to the ring
down timer expiration, then ring down does not occur. Ring down applies only to standard
telephone ports, not electronic or digital telephone ports. Ring down destination numbers are
assigned in Program *38.
Hotline or Emergency standard telephone waits after going off-hook before automatically ringing
a preassigned directory number. If a valid feature access code or [DN] is dialed prior to the ring
down timer expiration, then ring down does not occur. Ring down applies only to standard
telephone ports, not electronic or digital telephone ports. Ring down destination numbers are
assigned in Program *38.
Initialized Default:
Program Timing
Code 1
15 secs.
Code 3
1 min.
Code 4
2 secs.
Code 5
0 secs.
Code 8
1 min.
Code 9
4 secs.
✱ ✱ ✱ ✱ 6SNU +ROG 6SNU
+ROG 6SNU +ROG 6SNU +ROG
Program
Code
Function
Code
Time
Required
Code
1
Standard Telephone Ring Down Timer (Release 4.0)
XX
XX = 2 digits. 00~60 secs.
3
Pause Timing
(Speed Dial)
(Speed Dial)
1
1.5 sec
2
3.0 sec.
4
Flash Timing
1
0.5 sec.
2
2.0 sec. (Not used in U.S.)
4
0.2 sec.
5
Pause After Flash
(Voice Path Delay)
(Voice Path Delay)
0
no pause
1
1.5 sec.
2
3.0 sec.
7
SLT Toll Restriction DTMF Receiver time after Dial 9
XX
XX = 01~30 sec.
8
DNIS Ext. Network, External Call Forward, and DISA
Disconnect Timer for Loop Start Lines
Disconnect Timer for Loop Start Lines
0
no disconnect timer
1
4 min. disconnect
2
10 min. disconnect
3
20 min. disconnect
9
QRCU3/K4RCU3/RRCS/BRCS DTMF Inter-digital
Release Time (Standard Phone)
Release Time (Standard Phone)
XX
XX = 01~09 secs.
SELECT = 1, 3~5, 8, 9
Enter program code from
the table below.
Enter program code from
the table below.
DATA = Enter ring down time (00~60)
SELECT CODE = Enter the 1 digit code which
corresponds to the time listed in the table below.
corresponds to the time listed in the table below.
For Program Codes 8 and 9, the LCD responds with
LINE TIME =, instead of SELECT CODE =.
LINE TIME =, instead of SELECT CODE =.