Teledyne 200AH 用户手册

 

The M200AH has two main operating modes. The instrument is normally in SAMPLE mode 
when it is taking data or doing a calibration. The second main mode is the SETUP mode. In this 
mode the many features of the instrument can be altered, enabled or disabled. Within these two 
main modes there are many other operating modes which are shown in Table 5-7. The mode the 
instrument is operating in is shown in the upper left of the front panel display. 

ZERO CAL D 

Automatic dynamic zero calibration 

ZERO CAL A 

Automatic zero calibration 

ZERO CAL R 

Remote zero calibration 

ZERO CAL M 

Manual zero calibration 

SPAN CAL D 

Automatic dynamic span calibration 

SPAN CAL A 

Automatic span calibration 

SPAN CAL R 

Remote span calibration 

SPAN CAL M 

Manual span calibration 

M-P CAL 

Manual multi-point calibration 

DIAG ELEC 

Electrical diagnostic test 

DIAG OPTIC 

Optical diagnostic test 

DIAG OZONE 

Ozone generator diagnostic test 

DIAG AOUT 

D/A output diagnostic test 

DIAG 

Main diagnostic menu 

DIAG I/O 

Signal I/O diagnostic 

DIAG RS232 

RS232 output diagnostic 

SETUP x.x 

Setup mode (X.X is software version) 

SAMPLE ZS 

Sampling; automatic dynamic zero and span calibration enabled 

SAMPLE Z 

Sampling; automatic dynamic zero calibration enabled 

SAMPLE S 

Sampling; automatic dynamic span calibration enabled 

SAMPLE A 

Sampling; automatic cal. Enabled 

SAMPLE 

Sampling; automatic cal. Disabled