Teledyne 200AH 用户手册

 

All of the default Data Channels sample more than one parameter, for these channels, each 
parameter is printed on a separate line. 

There is also a compact format. If this attribute is enabled, all 3 concentration parameters are 
printed on one line as shown below: 

D 94:08:00 0200 CONC : 120.0 100.0 20.0 

The parameters are in the order of NO

X

, NO, and NO

2

. 

To change any of the attributes of a particular data channel, the channel attributes are edited 
from the front panel. The following table uses the example of Automatic Reporting. Other 
attributes can be edited in a similar fashion. 

The M200AH operational modes are listed above. To list the analyzer's current mode type: 

V MODE

 

Lists M200AH current operational mode 

See Table 5-7 for list of operational modes and meanings. 

Model M200AH Internal variables 

The M200AH has a number of internal setup variables. Essentially all of these are set at time of 
manufacture and should not need to be changed in the field. A list of user accessible variables is 
shown in Table 9-5. 

A list of variables and their settings can be requested over the RS-232 port by: 

V LIST

 

Lists internal variables and values  

The output from this command is quite long and will not be shown here. The general format of 
the output is: 

name = value warning_lo warning_hi <data_lo> <data_hi>