Bowflex 1000 Benutzerhandbuch

Assembly Manual

    •  TreadClimber

®

 Base Assembly

    •  TreadClimber

®

 Treadle Assembly

    •  (4) 3/8” X 1 1/4” Hex Bolts (preassembled)

    Note:  Hardware is only hand tightened. Finish tightening 

the hardware in Step 1-5 below.

    •  9/16” Open End Wrench (included)
    •  Scissors or other cutting tool
    •  Ruler

    Note: This step requires two people.

1-1   Unlock the latch lever (see Figure 1-1).

1-2   Lower the tower treadle assembly onto base with two 

people. 

1-3   Align roller casting flush to the base (See Figure 1-2)

1-4   Use a ruler to center the treadles between the upright 

bases.

1-5   Tighten the (4) 3/8” x 1 1/4” Hex Bolts on the rear roller 

casting and base with the 9/16” open end wrench (See 
Figure 1-3). 

Note: Tighten the outside bolts on the rear roller casting first,  

 

    then the inner bolts. 

1-6  Cut the treadle zip tie located underneath the treadles.