Bowflex 1000 Benutzerhandbuch

Assembly Manual

    •   TreadClimber

®

 Base and Treadle assembly from Step 3

    •   (1) Drive Belt

    •  3/16” Hex Key (included)

4-1   Position the drive belt over the roller pulley and the motor 

pulley (See Figure 4-1).

4-2   Make sure that the belt is installed correctly into the grooves 

of the pulleys (See Figure 4-2).

4-3   Remove the motor shipping bolt from the motor pan with 

the 3/16” hex key (See Figure 4-3). 

Note:  Removing the shipping bolt will make the drive belt tight with 

spring-loaded tension. Be sure to keep the bolt in a safe place 
in case the machine must be disassembled for shipping or part 
replacement.

4-4   Put the unit in the upright position.

Parts:

    •   TreadClimber

®

 Base and Treadle assembly from Step 2

3-1   Line up the treadles parallel to each other and cut the zip 

tie connecting them.

3-2   Move the locking lever down and to the left and then up into 

the locked position until it clicks (See Figure 3-1).

3-3   From the front of the machine, press down on each treadle 

individually until they lock into the down position.

      The treadles might unlock during workout if they are not fully engaged.