Panasonic CZ-RWST1U Bedienungsanleitung
2
2. NAMES AND OPERATIONS
1. Operation Display
Displays the operation status. (The fi gure
shows all the statuses.)
• The auto-fl ap display may be different,
shows all the statuses.)
• The auto-fl ap display may be different,
depending on the installed unit. (See
Page 13)
Page 13)
2. Start/Stop
button
Pressing this button once starts and pressing
again stops the operation.
again stops the operation.
3.
Fan speed button
4.
Swing/Wind Direction button
5.
Timer setting button
Use for operating with a timer.
6. Reset button
Use this button after changing the batteries.
7. Cover
Press at the top center and then slide down.
8. Transmitter
9.
Remote control sensor
Detects the temperature at the remote
controller when detection has been switched
to the remote controller by the sensor button.
Detects the temperature at the remote
controller when detection has been switched
to the remote controller by the sensor button.
10. Temperature setting buttons
raises the temperature setting.
lowers the temperature setting.
11. Filter button
CZ-RWSC1U
Press to turn off the fi lter lamp on the
receiver.
Press to turn off the fi lter lamp on the
receiver.
12. Mode Select button
Press to switch the operation mode.
13. Ventilation button
Use this when connected to an aftermarket
fan. Pressing this button starts and stops the
fan. When the air conditioner is started or
stopped, the fan starts or stops at the same
time. (
fan. Pressing this button starts and stops the
fan. When the air conditioner is started or
stopped, the fan starts or stops at the same
time. (
appears on the display of the
remote controller when the fan is operating.)
14. Address button
15. Sensor button
Use this when switching to detect the
temperature at the remote controller. At
shipping the default setting is set to detect
the temperature at the unit. At this time
temperature at the remote controller. At
shipping the default setting is set to detect
the temperature at the unit. At this time
is
shown on the display.
16. Clock button
Use this when setting the clock.
REMOTE CONTROLLER
One remote controller can control a group of up to eight indoor units.
(See Page 14)
(See Page 14)
From this page on the names of remote control
buttons will be abbreviated as the illustration of
the “button”.
E.g.: Start/Stop button
buttons will be abbreviated as the illustration of
the “button”.
E.g.: Start/Stop button
Æ
Instruction_eng.indd 2
Instruction_eng.indd 2
2012/01/27 16:25:31
2012/01/27 16:25:31