Panasonic AJ-D850P Benutzerhandbuch

– 72 –

713

MONI CH

 0000

MANU

SEL

0001

AUTO1

0002

AUTO2

714

REC CH1

0000

CH1

0001

CH2

0002

CH1+2

715

REC CH2

0000

CH1

0001

CH2

0002

CH1+2

716

REC CUE

0000

CUE

0001

CH1

0002

CH2

0003

CH1+2

718

DV

0000

ST1

OUTPUT

0001

ST2

0002

ST1+2

719

PB FADE

0000

AUTO

0001

CUT

0002

FADE

720

EMBEDDED

0000

OFF

AUD

0001

ON

722

INT SG

0000

OFF

0001

ON

The underline on the setting item denotes the initial setting.

This selects the monitor output.
0: The output is as selected in MONITOR SELECT.
1: The output defaults to CUE except when speed factor is

between –0.43

×

 and 1

×

, inclusive, in which case output is

PCM AUDIO.

2: The output defaults to CUE except in PLAY mode, in which

case output is PCM AUDIO.

<Note>
These menu settings are valid when CH1 or CH2 has been
selected by the MONITOR SELECT L/R switches on the front
panel. (When CUE has been selected, the CUE signal will be
output at all speeds regardless of the above menu setting.)

This selects the input signal to be recorded on the audio CH1
track.
0: Audio input CH1 signal.
1: Audio input CH2 signal.
2: Mixed audio input CH1 and CH2 signal.

This selects the input signal to be recorded on the audio CH2
track.
0: Audio input CH1 signal.
1: Audio input CH2 signal.
2: Mixed audio input CH1 and CH2 signal.

This selects the input signal recorded in CUE.
0: CUE input
1: The signal selected in Setup Menu No. 714 is recorded.
2: The signal selected in Setup Menu No. 715 is recorded.
3: A mixed signal of the signals selected in Setup Menu No.

714 and Setup Menu No. 715 is recorded.

This selects the AUDIO CH1 and CH2 output signals during
DV or DVCAM format playback.
0: The CH1 track signals are output to CH1 and the CH2 track

signals to CH2.

1: The CH3 track signals are output to CH1 and the CH4 track

signals to CH2.

2: The mixed CH1 and CH3 track signals are output to CH1

and the mixed CH2 and CH4 track signals to CH2.

<Note>
This item setting is valid only when the tape recorded on the
four channels of the DV or DVCAM format is played back.

This selects the processing method for the audio edit points
(IN point, OUT point) during playback.
0: According to the status during recording.
1: Forced CUT
2: Forced FADE

This selects whether to superimpose the audio data onto the
serial output.
0: Data is not superimposed.
1: Data is superimposed.
<Note>
This item is valid when the optional serial interface board has
been installed.

This selects whether to use the internal signals as the audio
input signals.
0: The internal signals are not selected.
1: The internal signals are selected.
<Note>
The internal signals have a frequency of 1 kHz.