Golden Technologies GP160 Benutzerhandbuch

LiteRider PTC_Owner’s Manual                                                                                                                    Rev A_121911 

 
 

Arm Width Adjustment                                                                                                          
1.  Loosen the adjustment screw at the rear of the seat with a 4mm Allen wrench.  
     See figure 9.  
2.  Slide the arm in or out to the desired width.  

3.  Tighten the adjustment screw to secure the arm. 
4.  Repeat steps 1-3 to adjust the opposite arm. 
 

                                      

  

 
 

Note: The backrest can be folded down to minimize chair height during transport. 
 
Armrest Angle Adjustment 
1. Lift armrest up. See figure 10.  

2. Turn jam nut counter-clockwise to loosen.  
3. Turn the adjustment bolt using a 5mm Allen wrench to raise or lower the armrest-    
    angle. Turning the bolt counter-clockwise will raise the angle. Turning the bolt  
    clockwise will lower the angle. Turn until desired angle is reached. 

4. Re-tighten jam nut by turning clockwise. 
5. Repeat steps 1-4 on the opposite armrest. 
 

                                                             

  

 

                                                                                                                                       18 

Adjustment Bolt    
(5mm Allen) 

Jam Nut 
(14mm)