Motorola G24 Benutzerhandbuch

The following table shows the +ICF parameters.

This command indicates whether an antenna is physically connected to the G24 RF connector. 
This information is also provided by a dedicated hardware signal, which is outputted on pin 41 
(ANT_DET) of the interface connector.

Determines the number of bits in the data bits, the presence (or absence) of a parity 
bit, and the number of stop bits in the start/stop frame.
1

8 Data, 2 Stop - can be set only with <parity> 4

2

8 Data, 1 Parity, 1 Stop - can be set with <parity> of  0 or 1

3

8 Data, 1 Stop (default) - can be set only with <parity> 4

4

7 Data, 2 Stop - can be set only with <parity> 4

5

7 Data, 1 Parity, 1 Stop - can be set with <parity> of  0 or 1

6

7 Data, 1 Stop - can be set only with <parity> 4

7

8 Data, 1 Parity, 2 Stop - can be set with <parity> of  0 or 1

8

7 Data, 1 Parity, 2 Stop - can be set with <parity> of  0 or 1

Determines how the parity bit is generated and checked (if present).
0

Odd

1

Even

4

No parity (default)

The Read command indicates whether 
the antenna is connected.