Motorola G24 Benutzerhandbuch
Chapter 3: AT Commands Reference
December 31, 2007
AT Commands Reference Manual
3-207
The following table shows the ATS97 parameters.
Example
// Connect the antenna
ATS97?
001
ATS97
OK
ATS97=?
ERROR
// Disconnect the antenna
ATS97?
000
+MRST, Perform Hard Reset
The +MRST command enables customer software to perform a hard reset to the G24 unit. This
command provides a software simulation for pressing the power-off button. The command can be
sent to the G24 unit from each of the MUX channels.
command provides a software simulation for pressing the power-off button. The command can be
sent to the G24 unit from each of the MUX channels.
Example
AT+MRST
OK
// Result - G24 module performs a power down
+TWUS, Wakeup Reason Set
This command is used to set or query the wakeup reason(s).
This command allows selecting one or multiple events to wake the terminal connected to the G24.
When any of the selected events occurs, the G24 asserts the Wakeup Out line to low to wake the
terminal.
When any of the selected events occurs, the G24 asserts the Wakeup Out line to low to wake the
terminal.
Table 3-135: ATS97 Parameters
<Parameter>
Description
<info>
000
The antenna is not connected
001
The antenna is connected
Command Type
Syntax
Response/Action
Remarks
Set
+MRST
OK
The Set command performs a graceful
hard reset to the G24 module.
hard reset to the G24 module.
Note:
The Read and Test commands
are not permitted for the
+MRST command.
are not permitted for the
+MRST command.