3M 2273M Benutzerhandbuch

78-8130-6150-0 Rev G 

41

D. Dual Marker Locate

1.  Press Locate/OK [5].
2.  Press Marker [SK]. 
3.  Press MARKR 1 [SK Toggle] to select desired 

utility.

4.  Press MARKR 2 [SK Toggle] to select desired 

utility.

 

− The third and fourth soft key commands will populate with the types of utilities 

selected for Marker 1 and Marker 2.

5.  Adjust the Gain [4] down until the bar graphs open.

 

− The bar graph will close, the audio will increase, and the Signal Strength [10]

will increase when the receiver detects a marker of the specified utility.

 

− When one of the two markers is detected, press the “XXX Only” [SK] for the 

detected utility marker. ("XXX" represents the marker types selected. In the 

above example, PWR Only and TEL Only.)

 

− The receiver will switch to Single Marker Locate in order to pinpoint the 

marker.

6.  Press Markr 2 [SK Toggle] to return to Dual Marker Locate.

E. 3M

™

 iD Marker Depth

1.  Lower the tip of the receiver to the ground over the pinpointed marker.

2.  Press Depth [SK].

 

− The receiver will examine the marker 

(Calculating, please wait...)

 

− If the marker is a 3M

™

 iD Marker, the 

receiver will display the depth of the 

marker, and its identification serial 

number.