Harbor Freight Tools 68120 Benutzerhandbuch

Page 8

Horizontal Engines 

        

Inspect engine and equipment looking for damaged, loose, and missing parts before set up 

and starting.  If any problems are found, do not use equipment until fixed properly.
Checking and Filling Engine Oil
NOTICE:  Your Warranty is VOID if the engine’s 

WILL permanently damage the engine.
1.  Make sure the engine is stopped and is level.
2.  Close the Fuel Valve.
3.  Clean the top of the Dipstick and the area around it.  

Remove the Dipstick by threading it counterclockwise, 

and wipe it off with a clean lint free rag.

4. 

Full level

Full level

Reinsert the Dipstick without threading it in and 

remove it to check the oil level.  The oil level 

should be up to the full level as shown above.

5.  If the oil level is at or below the low mark add the 

appropriate type of oil until the oil level is at the 

proper level.  SAE 10W-30 oil is recommended 

for general use.  (The SAE Viscosity Grade chart 

on page 15 in the Service section shows other 

viscosities to use in different average temperatures.)

6.  Thread the dipstick back in clockwise.
NOTICE:  Do not run the engine with too little oil.