Honeywell MRP-2001E Benutzerhandbuch

Programming

MRP-2001 & MRP-2001E   PN 53040:A  4/16/2007

55

Pressing 2 while viewing the Noun/Adjective Screen will cause the following screen(s) to be 
displayed.  Note that the keyboard down arrow key must be pressed to see all the Noun screens.  
Press the number corresponding to the noun that is to be used as a descriptor for the location of 
the detector currently being programmed.  When a noun has been selected, it will appear at the 
top of the display as indicated by the asterisks.

The Description selection allows the programmer to enter additional information about the 
detector currently being programmed.  This information will be displayed as part of the device 
label on the display.  Pressing 2 while viewing Edit Input Zone Screen #3 will cause the 
following screen to be displayed: 

A flashing cursor will appear at the first asterisk to the left.  The programmer can enter 
additional descriptive information about the device being programmed.  This information will 
appear on the display along with the standard device label information.  

**********************
1=BASEMENT
2=BOILER RM
3=CLASSROOM

**********************
1=COMPUTER RM
2=CONTROL RM
3=DATA ROOM

**********************
1=DOCUMENT RM
2=ELECTRIC RM
3=GARAGE

**********************
1=HVAC RM
2=ISLAND
3=KITCHEN

**********************
1=ROOM
2=STOREROOM
3=TELCO ROOM

**********************
1=UPS ROOM
2=VAULT

  INPUT ZONE #
1=NOUN/ADJECTIVE
2=DESCRIPTION

Edit Input Zone Screen #3

ZONE # DESCRIPTION    

PRESS ENTER IF DONE
********************