Honeywell MRP-2001E Benutzerhandbuch

Programming

80

MRP-2001 & MRP-2001E   PN 53040:A  4/16/2007

Pressing 1 while viewing Programming Screen #4, will select the Clear Program option.  The 
control panel will provide a warning to the user by prompting with the following display: 

Pressing 1 for Yes will cause the control panel to carry out the selected clear option.  Pressing 2 for 
No will prevent programming from being cleared. 

The factory set passwords, which have been programmed into the control panel, can be changed by 
selecting the Password Change option.  Pressing 2 while viewing Programming Screen #4 will 
cause the following screen to be displayed:

Press 1 to change the Master Programming Level password or 2 to change the Maintenance Level 
password.  Note that the passwords will not be displayed on annunciators.

The following screen will appear when either change option is selected:

A flashing cursor will appear in the center of the display.  Enter a new five digit password (such as 
10101 for the Master Level).  After the fifth digit is entered, the following screen will be displayed:

The new five digit password must be re-entered to accept the change. The display will then return 
to the initial Password Change Screen.

   PROGRAMMING
1=CLEAR PROGRAM
2=PASSWORD CHANGE

Programming Screen #4

      WARNING!
  SYSTEM CHANGE
     PROCEED?
1=YES           2=NO

  PASSWORD CHANGE
1=MASTER
2=MAINTENANCE

ENTER NEW FIVE DIGIT
      PASSWORD
        

     VERIFY NEW 
      PASSWORD