JVC LYT1805-001A Benutzerhandbuch

Basic Recording

Preparation:

•  Power ( 16).

•  Load a cassette ( 18).

•  Remove the lens cap ( 9).

•  Open the LCD monitor fully ( 12).

•  Select videos at 4:3 size or 16:9 (wide) size  

( 18).

1

  Set the 

MEMORY/VIDEO Switch to 

“

VIDEO” ( 13).

2

  Set the Power Switch to “

REC” ( 13).

3

  Press the Recording Start/Stop button 

to start recording. “REC” appears on the 
display while recording is in progress. To 
stop recording, press the Recording Start/
Stop button again.

30 min.

30 min.

45 min.

60 min.

60 min.

90 min.

80 min.

80 min.

120 min.

Notes:

•  If the Record-Standby mode continues for 5 

minutes and no operation is performed, the 

camcorder’s power shuts off automatically. To 

turn the camcorder on again, close and re-

open the LCD monitor.

•  When a blank portion is left between 

recorded scenes on the tape, the time code is 

interrupted and errors may occur when editing 

the tape. To avoid this, refer to “Recording 

From The Middle Of A Tape” ( 20).

•  To record in LP (Long Play) mode,  31.

Tape Remaining Time

Approximate tape remaining time appears on 
the display. “– – – min” means the camcorder 
is calculating the remaining time. When 
the remaining time reaches 2 minutes, the 
indication starts blinking.

•  The accuracy of the calculation, may vary 

according to the type of tape used.

Quick Review

Enables you to check the end of the last 
recording. 

Tape is rewound for about several seconds 
and played back automatically, then pauses in 
the Recording-Standby mode for the next shot.

•  Distortion may occur at start of playback. This 

is normal.

•  Slide the Zoom lever repeatedly to change the 

sound to on/off.

Appears if a tape is not loaded when the 

Recording Start/Stop Button is pressed.

Appears if dirt is detected on the heads during 

recording. Use an optional cleaning cassette  

( 4).