JVC LYT1805-001A Benutzerhandbuch

Audio Dubbing

The audio track can be customized only when 
recorded in the 12-BIT and SP modes ( 31).
•  Use the provided remote control.

1

  Play back the tape to locate the point 

where editing will start, then press  
PAUSE (

8).

2

  While holding 

A. DUB (D) on the remote 

control, press 

PAUSE (

8). The “8D” 

indicator appears.

3

  Press 

PLAY (

3), then begin “narrating”. 

Speak into the microphone.

•  To pause dubbing, press 

PAUSE (

8).

4

  To end Audio Dubbing, press 

PAUSE (

8), 

then 

STOP (

7).

To hear the dubbed sound during playback
Set “NARRATION” to “ON” or “MIX”  
( 29, 34).

Notes:

•  Sound is not heard from the speaker during 

Audio Dubbing.

•  When editing onto a tape that was recorded 

at 12-BIT, the old and new soundtracks are 

recorded separately.

•  If you dub onto a blank space on the tape, the 

sound may be disrupted. Make sure you only 

edit recorded areas.

•  If feedback or howling occurs during TV 

playback, move the camcorder’s microphone 

away from the TV, or turn down the TV’s 

volume.

Insert Editing

You can record a new scene into a previously 
recorded tape, replacing a section of the 
original recording with minimal picture 
distortion at the in and out points. The original 
audio remains unchanged.
•  Use the provided remote control.

Notes:

•  Before performing the following steps, make 

sure that “TIME CODE” in both Recording and 

Playback Menus is set to “ON”. ( 29, 34).

•  Insert Editing is not possible on a tape 

recorded in the LP mode or on a blank portion 

of a tape.

1

  Play back the tape, locate the Edit-Out 

point and press 

PAUSE (

8). Confirm the 

time code at this point ( 20).

2

  Press 

REW (

1) until the Edit-In point is 

located, then press 

PAUSE (

8).

3

  Press and hold 

INSERT (I) on the remote 

control, then press 

PAUSE (

8). The “8I” 

indicator and the Time Code (min.:sec.) 
appear and the camcorder enters Insert- 
Pause mode.

4

  Press 

START/STOP to begin editing.

•  Confirm the insert at the time code you 

checked in step 

1

.

•  To pause editing, press 

START/STOP. 

Press it again to resume editing.

5

  To end Insert Editing, press 

START/STOP, 

then 

STOP (

7) on the remote control.

Notes:

•  Program AE, Effects and Shutter Effects  

( 39) can be used to spice up the scenes 

being edited during Insert Editing.

•  During Insert Editing, the date and time 

information changes.

•  If you perform Insert Editing onto a blank 

space on the tape, the audio and video may be 

disrupted. Make sure you only edit recorded 

areas.

•  During Insert Editing, when the tape moves 

to scenes recorded in the LP mode or a blank 

portion, Insert Editing stops.