JVC LYT1805-001A Benutzerhandbuch

Dubbing To Or From A Video 

Unit Equipped With A DV 

Connector (Digital Dubbing)

It is also possible to copy recorded scenes 
from the camcorder onto another video unit 
equipped with a DV connector. Since a digital 
signal is sent, there is little, if any, image or 
sound deterioration. 

1

  Make sure all units are turned off.

2

  Connect this camcorder to a video unit 

equipped with a DV input connector using 
a DV cable as shown in the illustration.

3

  Start playback on the camcorder ( 21).

4

  At the point you want to start dubbing, start 

recording on the video unit. (Refer to the 
video unit’s instruction manual.)

5

  To stop dubbing, stop recording on the video 

unit, then stop playback on this camcorder.

Notes:

pack ( 16).

•  If a blank portion or disturbed image is played 

back on the player during dubbing, the dubbing 

may stop so that an unusual image is not 

dubbed.

•  Even though the DV cable is connected 

correctly, sometimes the image may not 
appear in step 

4

 

. If this occurs, turn off the 

power and make connections again.

•  If “Playback Zoom” 

( 23) or “Playback 

Special Effects” ( 23) is attempted or 
SNAPSHOT is pressed during playback, 
only the original playback image recorded 
on the tape is output from the DV IN/OUT 
connector.

1

  Make sure all units are turned off.

2

  Connect this camcorder to a video unit 

equipped with a DV output connector using 

a DV cable as shown in the illustration.

3

  Set the camcorder’s Power Switch to “

PLAY”.

4

  Set “REC MODE” to “SP” or “LP” ( 31).

5

  Start playback on the player.

6

  Press the Recording Start/Stop Button to 

engage the Record-Pause mode.

•  The “ 

 ” indication appears on the 

screen.

7

  At the point you want to start dubbing, 

press the Recording Start/Stop Button to 

start dubbing. The T indication rotates.

8

  Press the Recording Start/Stop Button 

again to stop dubbing. The T indication 

stops rotating.

9

  Press 8 to return to the normal playback 

mode.

Note:

Digital Dubbing is performed in the sound mode 

recorded on the original tape, regardless of the 

current “SOUND MODE” setting ( 31).

Appears if dubbing of copyguarded signals is 

attempted while this camcorder is being used 

as a recorder.