Dixon ZTR 3302 Benutzerhandbuch

1.  The 3302 has a two -piece polyethylene body. The upper body can be folded forward to 

expose the transaxle. In some cases, it may be necessary to  remove the upper body to 
service the transaxle.

2.   To remove upper body, remove two bolts P/N 3093 from the front of upper body hinge 

located on the brake shaft P/N 9283. Disconnect seat switch P/N 4761 at plug -in.

3.   Reverse above procedure to reinstall.

1.   This mower deck drive belt is tensioned by a spring loaded engagement idler quadrant.

2.   This system is designed to maintain the proper belt tension at all times.

3.   Belt tension can be adjusted by moving the engaging rod P/N 7013 into the outside hole  of 

engagement handle P/N 7020.

4.   After belt tension is adjusted, check to assure that the mower blade will not turn freely when 

the engaging rod is in the "OFF" position.

5.   lf the mower blade turns  freely, adjust the blade brake b y loosening nut P/N3205 at 

the  end of the brake rod P/N 2988.

6.   After adjustment is achieved, perform the safety checks listed below.

Secure blade P/N 2483 from turning. Remove blade bolt  from  center  of blade P/N 3268, and 
blade washer P/N 6260 then remove blade P/N 2483. To reinstall, reverse above procedure. 
Tighten blade bolt to 60 ft. Ibs. of torque.

WARNING:  

Sharp edges on blade can cause injury!

Caution should be exercised when service is required on blade.

1.     Loosen belt keepers P/N 7026 & 7027 located under the engine by loosening the mounting 

bolts, allowing the deck drive belt to come free of the rear pull ey.

2.    Disconnect the wiring loom at the deck safety switch P/N 4242.

3.    Remove the two clevis pins P/N 3072 from the two rear L -rods P/N 1355 and slide from slots.

4.    Remove clevis pin P/N 3072 from L -rod attached to lift handle and slide from slot.

5.     Remove clevis pin P/N 3072 from front deck hanger shaft P/N 1332, located at front of 

mower deck on slide plates welded at battery box, and remove.

6.     Lift front of mower chassis clear of deck. Roll chassis free of the deck.

7.      To install, reverse the above procedure. 

-            Page 2 of 8