Dixon ZTR 3302 Benutzerhandbuch

Seite von 8
MOWER BLADE OPERATION
 
To engage mower blades, turn engagement lever on floor slowly to the "ON" position. To 
Disengage mower blades, turn lever  slowly to the "OFF" position.
 
SAFETY CHECKS
 
IMPORTANT-   PERFORM SAFETY CHECKS AFTER MAKING ANY REPAIRS OR ADJUSTMENTS 
1.  
After reassembly, while seated on mower, attempt to start engine with mower deck 
engaged. Engine should not start. If engine does start, return the mower to an Authorized 
Dixon dealer for adjustment or repair.
 
2.     Disengage mower deck and start engine. With the operator in the normal seated position, 
engage mower deck and remove weight from seat. The engine should stop. If the engine 
does  not  stop when operator rises from seat, return the mower to an Authorized Dixon 
dealer for adjustment or repair.
 
3.     Engage,  then disengage mower  blade in each cutting height. Insure that blade 
disengages and comes to a stop within (5) seconds in each height position. If blade does 
not disengage properly, contact your Authorized Dixon dealer.
 
CAUTION: DO NOT OPERATE MOWER IF ANY SAFETY FEATURE IS NOT FUNCTIONING CORRECTLY 
PARKING BRAKE ADJUSTMENT
 
Remove the body as described above. Tighten nut on brake rod P/N 2533 located in front of 
the transaxle on each side, just enough to prevent brake from slipping when engaged.
 
CAUTION: Over-tightening may cause premature wear on the brake band P/N 5085
 
Revised 7/93 P/N 
8114
 
Page 3 of 8