Panasonic AJSPC700P Benutzerhandbuch

18

This connector is used to input a reference signal before
the camera unit is gen-locked, or before the time code is
externally locked. 

This connector is used to input a reference time code
when you externally lock the time code.

When you inter-lock the time code of the AJ-SPC700P
with that of an external device this must be connected
with the time code input (TC IN) connector of the
external device.

Pressing this button freezes the time data indication on
the counter. Note that time code generation continues.
Pressing the button again reactivates the counter.
This function is used to ascertain the time code or CTL
count of a particular recorded scene. 

This button resets the time data (CTL) on the counter to
“00:00:00:00”.
If this button is pressed when with the 

 TCG switch

positioned at [SET], time code and user’s bit data are
reset to 0, and real-time data is reset to the initial value.

Indications of the time code, CTL and user bits on the
counter of the display window depend on the positions
of this switch and the 

 TCG switch.

Pressing the 

 HOLD button also displays Date/Time/

Time Zone.

 User bits indicated.

 Time code indicated. 

CTL:  CTL indicated.

This switch is used to specify the stepping mode for the
built-in time code generator.

Select this position to continuously advance
the time code independently of the P2 card
recording status. 
Use this mode to synchronise the time code
with the time of day, or to externally lock the
time code.

Select this position to set the time code and/or
user bits.

R-RUN: Select this position to advance the time code

only during recording.
For spliced scenes recorded on P2 cards, the
sequence of time codes is unbroken.

Use these buttons to set the time code and user bits.
The four triangular buttons are the CURSOR buttons,
and the center rectangular one is the SET button.
For guidance in setting the time code and user’s bit, see
[4-5 Setting Time Data].

#,52%2 'PINKUJDQQMࡍ࡯ࠫ㧞㧜㧜㧢ᐕ㧡᦬㧝㧝ᣣޓᧁᦐᣣޓඦ೨㧥ᤨ㧠㧡ಽ