Panasonic AJSPC700P Benutzerhandbuch

95

If a problem is detected immediately after the power is turned on, or during operation, this will be indicated by the WARNING 
lamp, lamps inside the viewfinder and a warning tone. 

The WARNING lamp has the highest priority, followed by the tally lamp, and then the warning tone. When multiple errors occur 
simultaneously a higher priority indication will be triggered. The [WIRELESS RF], however, may not be indicated, depending 
on the menu setting. 

The error code lights up.

Blinks 4 times per second. 

Blinks 4 times per second. 

The SYSTEM ERROR indication and the
error code light up. 

Beeps continuously. 

An error in the reference signal or the
communication. 

The operation stops. 

Please confirm [7-3-2 Error Codes] and
consult your distributor. 

All 7 bar indicators for battery remaining
capacity start blinking. 

Lights up. 

Blinks once per second. 

The BATT LED lights up. 

Beeps continuously. 

The battery has run out. 

The operation stops. 

Replace the battery. 

Error code E-30 appears.

Blinks 4 times per second.

Blinks 4 times per second.

The “TURN POWER OFF” indicator blinks.

Continues to beep.

The P2 card being accessed has been
removed, resulting in an error in the internal
memory of the camera-recorder.

Cannot be performed.

Turn off the power to the camera-recorder. If
there is an error in a clip on the removed P2
card, repair the clip.

All 7 bar indicators for remaining MEDIA
capacity start blinking. 

Continues to light up until an operation is
performed. 

Continues to blink 4 times per second until
an operation is performed. 

The WP indicator blinks. 

Continues to beep until an operation is
performed. 

The inserted P2 cards are write-protected. 

Recording is disabled. 

Disable the write-protect or replace the P2
card. 

#,52%2 'PINKUJDQQMࡍ࡯ࠫ㧞㧜㧜㧢ᐕ㧡᦬㧝㧝ᣣޓᧁᦐᣣޓඦ೨㧥ᤨ㧠㧡ಽ