Panasonic AG-HMC70P Benutzerhandbuch

Others

112

Problem

Check points

This unit cannot be
operated though
powered up.

This unit does not
operate normally.

≥Press the RESET button. (

l 115) If normal conditions are not

restored yet, remove the battery or AC adaptor, wait about 1 minute
and then reconnect the battery or AC adaptor. Then about 1 minute
later, turn on the power again. (Conducting the above operation
while the card is being accessed may damage the data on the
SD card.)

The remote control does
not function.

≥Does the grip belt not hide the remote controller receiver sensor?

# Please take care so that the grip belt does not hide the remote

controller receiver sensor.

≥Has the button-type battery of the remote control run out?

# Replace it with a new button-type battery. (l 25)

A function indication
such as the remaining
time indication or the
elapsed time indication is
not shown.

≥If you set [SETUP]

> [DISPLAY] > [OFF], indications other than

warnings and date indications disappear.

Recording does not start
although power is
supplied to this unit and
the SD card is correctly
inserted.

≥Has the SD card’s write protect switch been set to LOCK?

# No recording is possible while the write protect switch is set to

LOCK. (l 28)

≥Is the memory of the SD card full?

# If there is no more available memory, free up some memory by

deleting unnecessary scenes or use a new SD card. (l 34, 73,

75)

≥Is the unit set to recording mode?

# No recording is possible if the mode dial is set to other than

≥Is the card slot cover open?

# If the card slot cover is open, this unit may not operate normally.

Close the card slot cover.

The unit arbitrarily stops
recording.

≥Can the SD card be used for motion picture recording?

# Use an SD card that can be used for motion picture recording.

(l 27)

VQT1Q93_ENG_PP.book 112 ページ２００８年３月６日　木曜日　午後５時４２分