Panasonic AG-HMC70P Benutzerhandbuch
41
Setup
Setting date and time
When the unit is turned on for the first time, a
message asking you to set the date and time will
appear.
≥Press the button up or down button of the
message asking you to set the date and time will
appear.
≥Press the button up or down button of the
cursor button to select [YES], press the center
of the cursor button and then perform steps 2
and 3 below to set the date and time.
of the cursor button and then perform steps 2
and 3 below to set the date and time.
If the screen shows the incorrect date and time,
then adjust it.
then adjust it.
¬
Rotate the mode dial to select
.
1
Press the MENU button, then
select [BASIC]
select [BASIC]
#
[CLOCK SET]
#
[YES]
and press the center of the
cursor button.
2
Select the item to be adjusted by
pushing the right or left button of
the cursor button, and then press
the center of the cursor button to
make the selection. Make any
further adjustments by pushing
the up or down button.
pushing the right or left button of
the cursor button, and then press
the center of the cursor button to
make the selection. Make any
further adjustments by pushing
the up or down button.
≥The year will change as follows:
2000, 2001, ..., 2039, 2000, ...
≥The 12-hour system is used to display the
time.
3
Press the center of the cursor
button to enter the selection.
button to enter the selection.
≥The clock function starts at [00] seconds
when the cursor button is pressed.
≥After pressing the MENU button to finish
the setting, check the date and time
display.
display.
Changing the date and time display style
Press the MENU button, then select [SETUP]
#
[DATE/TIME]
# desired display style and press
the center of the cursor button.
≥You can also show or change the date and time
≥You can also show or change the date and time
display by repeatedly pressing the DATE/TIME
button on the remote control.
button on the remote control.
Changing the display style
Press the MENU button, then select [SETUP]
#
[DATE FORMAT]
# desired display style and
press the center of the cursor button.
≥The date and time function are driven by a
built-in lithium battery.
≥Make sure to check the time before recording.
≥If the time display becomes [- -], the built-in
≥If the time display becomes [- -], the built-in
lithium battery has run down. Use the following
steps to charge the battery. When you turn on
the power for the first time after charging, a
message asking you to set the date and time
will appear. Select [YES] and set the date and
time.
steps to charge the battery. When you turn on
the power for the first time after charging, a
message asking you to set the date and time
will appear. Select [YES] and set the date and
time.
To recharge the built-in lithium battery:
If you connect the AC adaptor or insert the
battery in this unit, the built-in lithium battery will
be recharged. Leave the unit as it is for approx.
battery in this unit, the built-in lithium battery will
be recharged. Leave the unit as it is for approx.
15
DEC
2008
03 30 PM
[DATE]
[D/T]
[OFF]
Display style
Screen display
[Y/M/D]
2008.12.15
[M/D/Y]
DEC 15 2008
[D/M/Y]
15.12.2008
DEC.15. 2008 3:30PM
DEC.15. 2008
VQT1Q93_ENG_PP.book 41 ページ ２００８年３月６日 木曜日 午後５時４２分