Geneva Lab 3205 Benutzerhandbuch

 

26 

- 

 

KEY STUCK 

A key on the user keypad has been closed continuously for >15 
seconds 

WATER LEAKAGE   

The hot inlet valve has had to be switched on > 30 times since 
the last vend was taken 

NO CUPS      

Comes into force after 2 unsuccessful attempts to drop a cup 

ELECTRONICA 

Internal serial communication failure between the control board 
and the RIO board 

IO CONFIG ERR.    

Board has not been initialized using the ENG LINK 

WASTE TRAY FULL 

Either the Liquid or Coffee ground waste bucket is full of water 

HEATER INHIBITED 

The heater tank has not filled within the 3.5 minute time limit 

PLACE OWN CUP   

Sold-out of cups 

FILLING BOILER 

Comes into force 15 seconds after starting to fill the heater tank 
with water. Indication of a slow rate of fill 

C BREWER FAULT 

Brewer unit is not cycling correctly – a motor or cycle-switch fault  

NEW FILTER REQD 

Filter belt warning (if activated) – comes into force after air 
pressure seen to be present after 7 seconds 

FILTER BROKEN   

Brewer Fault – comes into force after air pressure has seen to be 
present after 20 seconds during a vend 

DOOR FAULT    

Cup door mechanism is not cycling correctly - a motor or cycle-
switch fault 

 
NOTES: 

1) 

The event log will only record events that persist for two or more consecutive event log checks. Event 
log checks take place once every 60s, so in the worst case scenario an event may have to be in force 
for almost 120s before it is recorded. 

2) 

The event log does not handle concurrent events. If two (or more) fault conditions are active, only the 
first occurrence will be recorded.