Panasonic KX-TVP200 Benutzerhandbuch
2.8 TERMINAL CONNECTION
46
Installation Manual
2.8
TERMINAL CONNECTION
2.8.1
Requirements for Connecting Programming Terminal
The programming terminal must be connected with a serial cable with an RS-232C connector
at the RS-232C port. This must be a null modem cable. This enables system administration
(system setup, mailbox setup, and system diagnosis) to be performed.
at the RS-232C port. This must be a null modem cable. This enables system administration
(system setup, mailbox setup, and system diagnosis) to be performed.
Communication parameters of the VPS have been set to the following values at the factory:
2.8.2
Connecting the RS-232C Cable
RECOMMENDED:
Before connecting the cable, switch off the power on both the data terminal and the
VPS.
VPS.
Insert the RS-232C cable into the VPS with the connector indicating the same direction.
The cable must be shielded and no longer than 2 m.
Table 2-5
COMMUNICATION PARAMETERS
Baud Rate:
9600 bps
Word Bit Length:
8 Bits
Parity:
None
Stop Bit Length:
1 Bit
Panasonic
Panasonic
RS-232C Cable
RS-232C port
Data Terminal
Or Printer
Or Printer