AT&T 7720 Benutzerhandbuch
32
Priority Call Signal
When a caller enters the Priority Calling Code from a touch tone phone,
the system beeps loudly to alert you that you have a priority call. You’ll
need to provide select callers with the Priority Calling Code (preset to
999), in order for them to use this feature.
the system beeps loudly to alert you that you have a priority call. You’ll
need to provide select callers with the Priority Calling Code (preset to
999), in order for them to use this feature.
1
Your caller
dials your telephone number from a touch tone phone.
2
When the announcement begins to play, your caller can enter the
Priority Calling Code.
Priority Calling Code.
3
The system beeps three times, then pauses. This continues for up to
30 seconds, unless you answer the phone.
30 seconds, unless you answer the phone.
4
If you do not answer, your caller can press 5 to stop the priority call
signal, and then enter a mailbox number to leave a message in a mailbox.
signal, and then enter a mailbox number to leave a message in a mailbox.
Changing the Priority Calling Code
The priority calling code comes set to 999, but you can change it to any
three-digit number from 500 to 999 following the directions below.
three-digit number from 500 to 999 following the directions below.
NOTE: Do not use the same code as the Remote Access Code. If you set the
Remote Access Code and the Priority Calling Code to the same number, the
phone will always interpret that number as the Remote Access Code.
Remote Access Code and the Priority Calling Code to the same number, the
phone will always interpret that number as the Remote Access Code.
1
Press
C.
2
Press and release
u until you hear “Priority Call Code is…” The
system announces the current Priority Calling Code.
3
Press
n or N to change the first digit. Press
u to move to the second digit.
4
Press
n or N to change the second digit. Press
u to move to the third digit.
5
Press
n or N to change the third digit. Press
u to save. The system announces the new Priority Calling Code.
Base Ringer Setting
1
Press
C.
2
Press and release
u until you hear “Base ringer is…” The Message
Counter displays
+
if the ringer is on;
–
if the ringer is off.
3
Press
n or N to change the setting. When you set
the ringer to off, the BASE RINGER OFF light on the base goes on.
Reviewing Feature Settings
To check the status of the feature settings, press
u.
ANSWERING SYSTEM SET-UP