Monessen Hearth EYF18 Benutzerhandbuch

Seite von 32
15
65D1009
EYF Series Unvented Gas Log Set
W
ARNING
LOG PLACEMENT
The positioning of the logs is critical to the safe and clean operation of 
this heater. Sooting and other problems may result if the logs are not 
properly and firmly positioned in the appliance. Never add additional 
logs or embellishments such as pine cones, vermiculite or rock wool 
to the heater. Only use the logs supplied with the unit. 
Failure to position the parts in accordance with diagrams below or to use 
only parts specifically approved for this heater may result in property 
damage or personal injury.
W
ARNING
Before  you  begin  —  This  unit  is  supplied  with  a  four 
ceramic  fiber  log  units.  Do  not  handle  the  log  unit  with 
your bare hands. Always wear gloves to prevent skin 
irritation from ceramic fibers.
 After handling the log unit, 
wash your hands gently with soap and water to remove 
any traces of fibers.
INSTALL EYF24-F LOG UNIT ON BURNER
Figure 18
1.  Install Main Log (#1) on middle and rear supports of 
base. Tabs should fit inside log center opening. Check 
log position and stability.
.  Install  Front  Log  (#)  in  front  of  burner  and  behind 
grate.
3.  Rest rear end Top Left Log (#3) in the indention on the 
main log. Line up hole in bottom of Top Left Log (#3) 
with slot on Front Log.
4.  Position rear end of Top Right Log (#4) on indention of 
main log. Rest front end of Top Right Log (#4) on front 
lot.
LG706
EYF24-F logs
Top Left Log 
#3
Top Right 
Log #4
Main Log 
#1
Front Log 
#
Tabs
Grate Bars
LG706
Figure 18 -
EYF24-F Log Placement
PLACE THE DECORATIVE ROCk 
DO NOT sprinkle volcanic rock on the logs 
or around the pilot or the main burner. This 
may cause sooting. Only place volcanic rock 
on the floor of the fireplace.
During  initial  operation  of  the  new  heater, 
burning logs will give off a paper burning 
smell  and  orange  flames  will  be  present. 
Simply open the windows for a few hours 
to vent the odor.