Wayne-Dalton 9100 Benutzerhandbuch

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the

Find a Dealer section online at www.wayne-dalton.com

DeTeRmiNe The wayNe-DalToN

TRack RaDiuS beiNg uSeD:

Trolley installation for

Standard lift

Measure the curved ends of the horizontal track

determine

if you have a 12” or 15” radius horizontal track,

as shown

in fIG. 2.1

. Determine center line of door. Mark vertical line

at this point, on the header wall. Raise the door slightly until
the top section reaches the highest point of travel (high arc)

Using a level, mark this high arc point of travel on the header
wall

, intersecting the vertical center line, as shown in fIG.

2.2 through 2.3.

Hold the wall bracket’s bottom edge to the

appropriate 1/2” - 1” (room permitting) above of the high
arc line and centered on the vertical line

, as shown in fIG.

2.3

. Spot the wall brackets mounting holes on the header

wall and then refer to your

garage door operator manual

for pre-drilling and securing the

wall bracket to header.

Using the OPERATOR HOOk-UP CHARTS, refer to referenced
illustrations in fIG. 2.4 through fIG. 2.5 for correct arm hook-
up from trolley to operator bracket.

NoTe: Refer to your operator manual for specific details on
how to assembly the curved and straight arm, as shown in
fIG. 2.4 through fIG. 2.5.

NoTe: Depending on your setup, you may or may not have to
cut straight arm to accomplish trolley settings, as shown in
fIG. 2.4 through fIG. 2.5.

HORIzONTAL

TRACk

12” OR 15”

FIG. 2.5

STRAIGHT

ARM

CURVED

ARM

CUT STRAIGHT ARM

TO ACCOMPLISH

TROLLEY SETTING

FIG. 2.4

CUT STRAIGHT

ARM TO

ACCOMPLISH

TROLLEY

SETTING

CURVED

ARM

STRAIGHT

ARM

oPeRaToR hook-uP chaRT STaNDaRD liFT FoR 15” RaDiuS

OPERATOR MODELS

TYPE Of ARM bEING USED

REf. ILLUSTRATIONS

AbOVE

qUANTUM/CLASSIC

CURVED / STRAIGHT

Fig. 2.5

LINEAR

STRAIGHT / CURVED

Fig. 2.4

LIfTMASTER

(SEARS)

CURVED / STRAIGHT

Fig. 2.5

GENIE

CURVED / STRAIGHT

Fig. 2.5

oPeRaToR hook-uP chaRT STaNDaRD liFT FoR 12” RaDiuS

OPERATOR MODELS

TYPE Of ARM bEING USED

REf. ILLUSTRATIONS

AbOVE

qUANTUM/CLASSIC

CURVED / STRAIGHT

Fig. 2.5

LINEAR

STRAIGHT / CURVED

Fig. 2.4

LIfTMASTER

(SEARS)

CURVED / STRAIGHT

Fig. 2.5

GENIE

CURVED / STRAIGHT

Fig. 2.5

FIG. 2.2

TOP

SECTION

HIGH ARC

LEVEL

FIG. 2.3

fROM

STEP 12

HIGH ARC

LINE

TYPICAL 1/2” - 1” AbOVE HIGH ARC

VERTICAL

CENTER LINE

HEADER

TORqUEMASTER

COUNTERbALANCE

FIG. 2.1