Wayne-Dalton 9100 Benutzerhandbuch

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your 

local yellow pages/business listings or go to the 

Find a Dealer section online at www.wayne-dalton.com

Tools Needed:

Tools Needed:

(4) 1/4”- 20 X 11/16” 

SELf DRILLING SCREWS

Power Drill

7/16” Socket 

Driver

Tape Measure

Install the side lock on the second 
section of the door. Secure the lock to 
the section with (4) 1/4”- 20 x 11/16” 
self drilling screws. Square the lock 
assembly with the door section and 
align with the square hole in the vertical 
track. The side lock should be spaced 
in approximately 1/8” from the section 
edge.

imPoRTaNT: SIDE LOCkS MUST bE 
REMOVED OR MADE INOPERATIVE IN 
THE UNLOCkED POSITION If AN 
OPERATOR IS INSTALLED ON THE 
DOOR.

NoTe: After completing this step, 
continue with step 7 on page 12.

1/8”

DO NOT INSTALL PULL ROPES 

ON DOORS WITH ELECTRIC 

OPERATORS. CHILDREN MAY 

bECOME ENTANGLED IN THE 

ROPE CAUSING SEVERE OR 

fATAL INjURY.

Measure and mark the jamb 
approximately 48” to 50” (1220 to 1270 
mm) from floor on the right or left side 
of door. Drill 1/8” pilot hole for No. 6 
screw eye. Install the No. 6 screw eye. 
Tie the pull rope to the No. 6 screw eye 
and to the bottom bracket as shown.

Power Drill 

1/8” Drill bit

NO. 6 SCREW EYE

PULL ROPE

bOTTOM 

bRACkET

PULL ROPE