New Buck Corporation MODEL FP-327-ZC Benutzerhandbuch

WARNING

IF YOU SMELL GAS:

* SHUT OFF GAS SUPPLY

* DO NOT TRY TO LIGHT APPLIANCE

* DO NOT TOUCH ANY ELECTRICAL SWITCH; DO NOT USE ANY

PHONE IN YOUR BUILDING

* IMMEDIATELY CALL YOUR GAS SUPPLIER FROM A NEIGHBOR’S

PHONE. FOLLOW THE GAS SUPPLIER’S INSTRUCTIONS.

* IF YOU CANNOT REACH YOUR GAS SUPPLIER, CALL THE FIRE

DEPARTMENT.

IMPORTANT: Operating heater where impurities in the air exist may create odors. Cleaning
supplies, paint, paint remover, cigarette smoke, cements and glues, new carpet or textiles, etc. create
fumes. These fumes may mix with combustion air and create odor.

OBSERVED
PROBLEM

H e a t e r p r o d u c e s a
clinking/ticking noise just
after burner is lit or shut
off

Heater produces unwanted
odors

Heater shuts off in use
(ODS operates)

Gas odor even when
control knob is in “OFF”
position

Gas odor during com-
bustion

POSSIBLE
CAUSE

1. Metal expands while heating

or contracts while cooling.

1. Heater burning vapors from

paint, hairspray, glues, etc.
(See Important above)

2. Low fuel supply
3. Gas leak (See WARNING

above)

1. Not enough fresh air is

available

2. Low line pressure
3. ODS/Pilot is partially clogged

1. Gas leak (See WARNING,

above).

2. Control valve defect

1. Foreign matter between

control valve and burner

2. Gas leak (See WARNING

above)

SOLUTION

1. This is common with most

heaters. If noise is excessive,
contact a qualified service
person.

1. Ventilate room. Stop using odor

causing products while heater is
running.

2. Refill supply tank
3. Locate and control all leaks. See

Checking Gas Connections.

1 . Open window/door for

ventilation

2. Contact local propane company
3. Clean ODS/Pilot

1. Locate and correct all leaks (see

Checking Gas Connections)

2. Replace control valve

1. Remove foreign matter from gas

tubing

2. Locate and correct all leaks (see

Checking Gas Connections)

Page 35