Monessen Hearth CSVF30SNV Benutzerhandbuch
18
58D6002
PIL
OT
OFF
REMO
TE C
ONTROL
4. Remove adhesive backing from plastic clip. Press
clip to bottom of valve. Clip thermo bulb into plastic
clip. See Figure 15.
5. Reattach faceplate or reinstall base.
6. Install knob to shaft of t-stat sensor. See Figure 14,
6. Install knob to shaft of t-stat sensor. See Figure 14,
page 17.
Figure 15 - Clipping Thermo Bulb into
Plastic Clip.
Valve
Thermo
Bulb
Plastic Clip
OPERATING THERMOSTAT SENSOR
1. Follow millivolt lighting instructions on lighting plate attached to unit or in homeownerʼs manual.
2. With control knob in the “ON” position make sure the ON/OFF switch is in the “OFF” position. See Figure 16.
3. The unit is now being controlled by the thermostat sensor. The sensor will now cycle the burners on and off. You can
2. With control knob in the “ON” position make sure the ON/OFF switch is in the “OFF” position. See Figure 16.
3. The unit is now being controlled by the thermostat sensor. The sensor will now cycle the burners on and off. You can
adjust how often the unit cycles by turning the control knob on the sensor.
Figure 16 - Control Knob in “ON” Position and ON/OFF Switch in “OFF” Position
Pilot
Optional
Fan
ELECTRICAL WIRING (MILLI-VOLT)
Hi/Lo
Knob
Piezo
Ignitor