Empire Products BF-30-2 Benutzerhandbuch

Seite von 20
16012-1-0504
Page 3
THIS IS A HEATING APPLIANCE
DO NOT OPERATE THIS APPLIANCE WITHOUT FRONT PANEL INSTALLED.
• Installation and repair should be done by a QUALIFIED
SERVICE PERSON.  The  appliance should be inspected
before use and at least annually by a professional service
person.   More frequent cleaning may be required due to
excessive lint from carpeting, bedding materials, etc.  It is
imperative that control compartments, burners and
circulating air passageways of the appliance be kept clean.
• DO NOT use this room heater if any part has been under
water.  Immediately  call a qualified service technician to
inspect the room heater and to replace any part of the
control system and any gas control which has been under
water.
• Keep appliance area clear and free from combustible
materials,  gasoline and other flammable vapors and liquids.
• WARNING: ANY CHANGE TO THIS HEATER OR ITS
CONTROLS CAN BE DANGEROUS.
Any safety screen or guard removed for servicing an
appliance must be replaced prior to operating the heater.
• WARNING: Failure to keep the primary air opening(s) of
the burner(s) clean may result in sooting and property
damage.
• An unvented room heater having an input rating of more
than 6,000 Btu per hour shall not be installed in a
bathroom
.
• An unvented room heater having an input rating of more
than 10,000 Btu per hour shall not be installed in a
bedroom or bathroom.
• Due to high temperatures,  the appliance should be
located out of traffic and away from furniture and
draperies.
• Children and adults should be alerted to the hazard of
high surface temperature  and should stay away to avoid
burns or clothing ignition.
• Young children should be carefully supervised when they
are in the same room with the appliance.
• Do not place clothing or other flammable material on or
near the appliance.
• Due to high surface temperatures, keep children, clothing
and furniture away.
• WARNING: Do not use a blower insert, heat exchanger
insert or other accessory not approved for use with
heater.
WARNING
When used without adequate combustion and ventilation
air, heater may give off CARBON MONOXIDE, an odor-
less, poisonous gas.
Do not install heater until all necessary provisions are
made for combustion and ventilation air.  Consult the
written instructions provided with the heater for infor-
mation concerning combustion and ventilation air.  In
the absence of instructions, refer to the National Fuel
Gas Code, ANSI Z223.1, Section 5.3 or applicable local
codes.
This heater is equipped with a PILOT LIGHT SAFETY
SYSTEM designed to turn off the heater if not enough fresh
air is available.
DO NOT TAMPER WITH PILOT LIGHT SAFETY
SYSTEM!
If heater shuts off, do not relight until you provide fresh air.
If heater keeps shutting off, have it serviced.  Keep burner
and control compartment clean.
CARBON MONOXIDE POISONING MAY LEAD TO
DEATH.
Early signs of carbon monoxide poisoning resemble the flu,
with headache, dizziness and/or nausea.  If you have these
signs, heater may not be working properly.  Get fresh air at
once!  Have heater serviced.
Some people — pregnant women, persons with heart or lung
disease, anemia, those under the influence of alcohol , those
at high altitudes — are more affected by carbon monoxide
than others.
The pilot light safety system senses the depletion of oxygen
at its location.  If this heater is installed in a structure having
a high vertical dimension, the possibility exists that the
oxygen supply at the higher levels will be less than that at the
heater.  In this type of application, a fan to circulate the
structure air will minimize this effect.  The use of this fan will
also improve the comfort level in the structure.  When a fan
is used to circulate air, it should be located so that the air flow
is not directed at the burner.
IMPORTANT SAFETY INFORMATION