Harman Stove Company P35I Benutzerhandbuch

15

Save These Instructions                                                                    3-90-775                                               Pellets or Corn/Pellet Mixture Only

If using a short run of venting, whether flex or rigid, 

through the damper and into the chimney flue; The 

Damper must be removed or locked in the open posi-

tion and sealed with a plate constructed of steel or 

other non-combustible material. 

Kaowool, mineral wool or other non-combustible insu-

lation is recommended above the plate to reduce the 

possibility of condensation. You will also need to wrap 

the venting section between the insert frame and the 

damper sealing plate. This is to prevent overheating 

of the fireplace cavity, which may cause damage to 

the insert's motors and other electrical components.

The connector pipe should extend through the sealing 

plate and smoke chamber and into, or beyond the first 

flue tile. 

--
--

Tile F

lue Liner

Non-combustible 

Insulation

Sealing Plate

When using single wall flex, this 
section of venting must be 
wrapped with non-combustible 
insulation to prevent excessive 
heat build-up in the cavity.

Be sure to design the venting so that it can be easily 

cleaned. 

Check with your local authority having jurisdiction to 

determine if this venting method is acceptable. Some 

Provincial, State, or Local codes may require a full  

liner run to the top of the chimney. Be sure and check 

your local regulations before planning the installation. 

In this method, the proper flashing and rain cap are 

also required. 

•  Masonry chimney must be in good condition

•  Meets minimum of NFPA 211 standard

•  Factory-built chimney must meet requirements 

of UL103 HT