Dimplex 7207250100R05 Benutzerhandbuch

7

Rear support

Main Body

Mantel top

Hardware

 

NOTE:  A 15 Amp, 120 Volt 

alternating current (VAC) circuit 

is required.  A dedicated circuit 

is preferred but not essential in 

all cases.  A dedicated circuit will 

be required if, after installation, 

the circuit breaker trips or fuse 

blows on a regular basis when the 

heater is operating.  Additional 

appliances on the same circuit 

may exceed the current rating of 

the circuit breaker.

 WARNINg:  Ensure the power 

cord is not installed so that it is 

pinched or against a sharp edge 

and ensure that the power cord is 

stored or secured to avoid tripping 

or snagging to reduce the risk 

of fire, electric shock or injury to 

persons.

 WARNINg: Construction 

and electrical outlet wiring must 

comply with local building codes 

and other applicable regulations 

to reduce the risk of fire, electric 

shock and injury to persons.

 WARNINg: Do not attempt 

to wire your own new outlets or 

circuits.  To reduce the risk of fire, 

electric shock or injury to persons, 

always use a licensed electrician.
(No assembly required for the 

assemble the top of the 

1. 

mantel to the rear support 

using the supplied hardware.
using the supplied hardware 

2. 

assemble the top and rear 

support assembly to the main 

fireplace body (Figure 1).

Make sure the unit’s Main 

1. 

ON/OFF switch is switched 

OFF (refer to operating 

instruction section).
Plug the unit into a 15 Amp, 

2. 

120 VAC outlet.  If the cord 

does not reach, you may use 

a No. 14 AWG minimum size 

extension cord rated for a 

minimum of 1875 Watts.