Amcor AMH8 Benutzerhandbuch

4

•  The heater must be mounted at four 

points. Two mounting holes (keyhole 
slots) are located on the upper rear of 
the heater and two wall mount angle 
brackets are provided for securing the 
heater’s bottom to the wall.

•   Fit the short edges of the angle brackets 

to the heater and secure brackets with 
the screws provided, ensuring the long 
tabs protrude downward (see Fig. 1). 

•   The heater must be positioned on a wall 

away from cold draughts or breezeways 
which may interfere with the tempera-
ture control system (rotary thermostat).

•   A clearance of at least 6" (152mm) to 

BOTH sides of the heater, at least 20 
inches (508mm) to the front and top of 
the heater should be maintained. 

•   A clearance of at least 8" (205mm) must 

be maintained above the fl oor or fl oor 
coverings (see Fig. 2).

•   The unit must NOT be positioned 

directly under a power outlet.

•   The unit should not be located

below air extraction vents.

1.  Mark the two screw points for the top 

mounting screws on the wall at dimen-
sions shown at right (Fig. 1) 17.75"
(451 mm) apart.

2.  Do not Screw Directly into 

sheetrock or paneling only.  

3.  Screws must be securely screwed 

into wall studs or by using suitable 
anchors (not supplied), not
completely, leaving 4-5 mm’s
(0.16" - 0.2"). Consult a qualifi ed
electrican if in doubt.

4.  Slide keyhole slots in heater over these 

two screws.

5.  Connect the two wall mount angle

brackets at the bottom of the unit as 
shown at right (Fig 1).

6.  Mark the two screw points (holes in the 

brackets).

7.  Repeat steps 2 & 3 above, only this time 

screws must be screwed completely.

Approximately 17

3

/

4

" between

the midpoints of the holes

At least 20" (508mm)

At least 

6" 

(152mm)

Install bottom of Heater not less than 8" (205mm) 
 above the fi nished fl oor.

Two Mounting Holes

Two Wall Mount Angle Brackets