Desa SPC-54PHW Benutzerhandbuch

www.desatech.com

114144-01A

ASSEMBLY INSTRUCTIONS

Continued

Figure 8 - Attaching Dome to Emitter

OPERATING

INSTRUCTIONS

WARNING: If you smell gas:

• Shut off gas to the appli-

ance.

• Extinguish any open ﬂames.

• If odor continues, immediately

call your gas supplier.

See safety warnings and precau-

tions starting on page 1 of this

manual for more information.

PREPARING FOR OPERATION

1. Check heater for possible shipping damage. If

any is found, immediately notify the factory.

2. Follow all safety information.
3. Check and assure control knob is in the "OFF"

position.

4. Place propane/LP gas cylinder inside cylinder

base. Securely connect regulator to propane/LP

gas cylinder.

5. Turn cylinder valve on. Apply a soap and

water solution to connection at regulator and

cylinder. Bubbles forming show a leak.

6. In case of any leaks, turn off propane/LP cyl-

inder valve, undo leaking connection. Check

and clean connection. Reconnect regulator and

leak test again.

START

1. Purge gas line leading to pilot assembly. Press

and turn control knob to HIGH position, keep-

ing it pressed in for 1 to 2 minutes. Note: When

a new or reﬁlled gas cylinder is installed, heater

will need to be purged again.

2. To light the pilot:

a) Press control knob and turn to the PILOT

position.

b) Hold control knob in and press ignition

button until the pilot lights.

c) Keep control knob depressed for 30 seconds

to heat thermocouple.

d) Release control knob and pilot should

remain lit. Note: To visually check igni-

tion of pilot, slide viewing hole cover to

either side.

e) Once pilot ﬂame stays on, close viewing

hole cover.

DOME AND EMITTER

Gently lay heater assembly on its side using one of

the shipping styrofoam inserts to prop up the top

half of heater. Align holes in dome with threaded

studs in emitter cover. Secure dome to emitter

using three cap nuts. Tighten with an adjustable

wrench. Stand heater back to upright position.