Haier HSU-09LEK13/R2(DB) Benutzerhandbuch

Operation

Unit start / stop

Press FAN button.

Remote controller:

Press

button

Every time the button is pressed, temp.setting

increase 1

C,if kept depressed, it will increase

rapidly

Every time the button is pressed, temp.setting

decrease 1

C,if kept depressed, it will

decrease rapidly

Select a desired temperature.

3.Fan function

2.Select temp.setting

Air conditioner is running under displayed fan speed.

When FAN is set to AUTO, the air conditioner

automatically adjusts the fan speed according to room

temperature.

1. Unit start

Press ON/OFF on the remote controller, unit starts.

Remote controller

changes as follows:

LOW

MED

AUTO

Display

circulated

Air Flow Direction Adjustment

1.Status display of air flow

When restart after remote turning off, the remote

return to the previous

2.Left and right air flow adjustment

Cautions:

When adjusting the flap by hand,turn off the unit.

When humidity is high,condensate water might occur

adjusted to left or

It is advisable not to keep horizontal flap at downward

position for a long time in COOLor DRY

otherwise, condensate water might occur.

at air outlet if all vertical louvers are

right.

mode ,

controller will automatically

Note:

set swing position.

Press button to enter additional options, when
cycle display to , will flash. And then press
enter to Left and right air flow function.

(This function is unavailable on some models.)

COOL/DRY:

HEAT:

Initial state

Press button to enter additional options, when
cycle display to , will flash. And then press

enter to up and down air flow function.

Press button. For each press,changes as follows:
Remote controller:

Press button. For each press,changes as follows:
Remote controller:
COOL/DRY/HEAT:

For each press button fan speed

In HEAT mode,warm air will blow out after a short

periodof the time due to cold-draft prevention function.

When FAN is set to AUTO, the air conditioner automatically

adjusts the fan speed according to room temperature.

Cooling only unit do not have displays and functions

related with heating

Display Board Remote

Controller

Note

COOL

DRY

HEAT

FAN

nothing

In DRY mode, when room temperature becomes

lower than temp.setting+2

C,unit will run intermittently

at LOW speed regardless of FAN setting.

Under the mode of auto operation, air conditioner will

automatically select Cool or Heat operation according

to room temperature.

air conditioner automatically adjusts the fan speed

temperature.

When FAN is set to AUTO, the

according to room

In FAN operation mode, the unit will not operate in

COOL or HEAT mode but only in FAN mode ,AUTO is

not available in FAN mode.And temp.setting is disabled.

In FAN mode,SLEEP operation is not available.

Operation

Mode

AUTO

Remote controller A:

Remote controller B:

Press button to enter additional options, when
cycle display to , will flash. And then press
enter to FAN function.

Loading of the battery

Remove the battery cover;

Load the batteries as illustrated.

2 R-03 batteries, resetting key

(cylinder);

Be sure that the loading

is in line with the

" + "/"-";

Load the battery,then put on the cover again.

The distance between the signal transmission head and the rece-

iver hole should be within 7m without any obstacle as well.

When electronic-started type fluorescent lamp or change- over

wireless telephone is installed in the

ver is apt to be disturbed in receiving the signals,

so the distance to the indoor unit should be shorter.

type fluorescent lamp or

room, the recei

Note:

Full display or unclear display during operation indicates the

ries have been used up. Please change batteries.

If the remote controller can't run normally during operation, please

reload several minutes later.

batte

remove the batteries and

Hint:

Remove the batteries in case won't be in use for a long period. If

there is any display after taking-out, just press reset key.