MartinLogan Home Theater System Benutzerhandbuch

Unpack the Script speakers with brackets attached and

the accessory kit. You should find:

2 ea. - Script speaker with bracket

4 ea. - wall anchors

4 ea. - #8 x 1 inch Phillips head screw

4 ea. - #12 black flat washers

4 ea. - 5/8 inch fiber washers

2 ea. - knob

2 ea. - knob with

inch - 1 inch stud

2 ea. - power cord (AC)

4 ea. - 1-

inch diameter spacer

WARNING! Installing the Script on a wall

requires only 1 person, but an assistant can

be helpful.

NOTE: To assure that your Scripts are safely wall mounted,

these instructions must be carefully followed. Study them

thoroughly before beginning to install your Scripts.

NOTE: The following instructions assume the mounting

surface is of standard wood frame and standard sheet rock

construction. If you wish to mount the Script to another

type of material, you should consult a bonded contractor.

The functional Script wall bracket is designed to mount the

Script securely to your wall and allows the Script to pivot

on a nearly 180 degree axis for maximum versatility.

Before you begin to install your Scripts on a wall, prepare a

work area—either on a carpeted floor or on a sturdy tabletop

covered by a soft blanket or other cloth to prevent damaging

the speaker cabinet.

The Wall Mount Bracket

The functional Script wall bracket is designed to hold the

Script securely to your wall and allows the Script to swing

on a nearly 180 degree vertical axis for maximum versatility.

The Script is shipped with the wall bracket mounted on

and positioned to the side of the speaker cabinet, pro-

tected by micro-foam packing material. Set the Script on

its side with the bracket facing up. Loosen the knob on

the bottom and the knob on the top. Swing the bracket

down until the bracket is nearly parallel to the back of

the Script (see figure 2, step A).

Loosen and remove the knob on the bottom of the

speaker—notice that the 5/8 inch fiber washer and 1-

inch diameter rubber spacer are shipped installed. The

fiber washer will come free when you remove the wing

nut—set the washer aside. Loosen and remove the knob

on top of the bracket while holding the bracket with

your free hand—set the fiber washer and 1-

inch rub-

ber spacer aside (see figure 2, step B).

Carefully pivot the top of the wall bracket away from

the Script until the wall bracket clears the top of the

speaker cabinet (see figure 2, step C). Next, move the

bracket down to free it from the threaded stud projecting

from the bottom of the speaker cabinet. Make sure that

the 1-

inch spacer remains on the projecting threaded

stud (see figure 2, step D). Finally, remove the micro-foam

packing material.

Preparing for Installation

Figure 2.

6 Mounting the Script

OUNTING THE

CRIPT