Hoover C1660-900 Benutzerhandbuch

Lift out filter (K) and hand wash in cold
water with a mild detergent.

Let filter air dry then reposition. Replace
lens and screws.

Should you want to replace this filter, ask
for 

(filter

package part no. 40110004).

The 

assists in returning clean

air to the room.

Using a screwdriver, remove the two
screws as shown and lift off lens. 

Grasp end of cartridge filter and gently
pull it away from pre-filter. Remove car-
tridge from assembly.

The pre-filter can be cleaned with a
brush and then rinsed with water. Allow
pre-filter to dry thoroughly.

It is recommended that the HEPA car-
tridge filter be cleaned by tapping either
of the ends until no more dust particles
fall from the filter. 

place large knob of cartridge filter in
hole on bottom of pre-filter.

Snap top of cartridge filter into place.

Align grooves (I) on pre-filter frame with
ribs (J) in dirt cup.

Slide filter assemby down into cup until
a light snap is felt. Gently pull up on
assembly to ensure that it is seated
properly in the cup. Ensure that no part
of pre-filter screen extends above top
edge of dirt cup.

Replace lid and return cup to cleaner
(Fig. 3-4). 

Using a screwdriver, remove the two
screws as shown and lift off lens.

This cleaner uses a 12 volt, wedge base
type 912 bulb, 

- Pull old bulb straight

out of socket.  Push new bulb straight
into socket until locked in place.