Hoover C1660-900 Benutzerhandbuch

With lettering to the outside of belt, slide
new belt along side of cleaner cavity
and over motor pulley (C).

Insert agitator through belt and place
belt in belt guide (D).

With the handle in the upright position,
tilt cleaner back until it rests on floor.

Remove the 2 screws near the front of
the brush roll cavity.

The belt on your Hoover cleaner causes
the agitator to rotate and is important for
the effective operation of the cleaner.
The belt is located under the hood of the
cleaner and should be checked from
time to time to be sure it is in good con-
dition.

To check belt, remove hood and agitator
cover as shown in Figs. 3-16 through 3-
19. Replace belt if it is stretched, cut or
broken.

To assure effective operation, use only
genuine HOOVER belts with your
cleaner. When purchasing a new belt,
ask for 

(belt package part no. 40201190).

Press on handle release pedal (A) and
lower the nozzle so it is flat.

Remove hose end (Fig. 2-13).

Remove 2 screws at rear of hood.

- Reposition lens (L)

and secure with the two screws.

Remove the 2 screws behind the 
agitator cover.

Remove agitator cover (B).

Lift hood off cleaner.

Remove agitator and used belt.

Discard used belt.

Continued ➜