Windsor SC20 Benutzerhandbuch
CONTROLS – NON TRACTION
SABER (SC) 86038350 01/29/07
3-6
1. BRUSH
SWITCH
Controls the scrub brush motor.
To turn scrub brush on, press the top of the
switch.
To turn scrub brush off, press the bottom of
the switch.
2. BRUSH LIFT LEVER
Raises and lowers the brush.
To lower the brush, lift the lever from the
notch, move to the left, then lower.
To raise the brush, lift the lever from its
lowered position.
To lower the brush, lift the lever from the
notch, move to the left, then lower.
To raise the brush, lift the lever from its
lowered position.
3. VACUUM
SWITCH
Controls the vacuum motor.
To start vacuum motor, press the top of the
switch.
To stop vacuum motor, press the bottom of
the switch.
To start vacuum motor, press the top of the
switch.
To stop vacuum motor, press the bottom of
the switch.
4. SQUEEGEE LIFT LEVER
Raises and lowers the squeegee.
To lower the squeegee, lift and pull the lever
to the left and then lower.
To raise the squeegee, lift the lever and push
it to the right.
To lower the squeegee, lift and pull the lever
to the left and then lower.
To raise the squeegee, lift the lever and push
it to the right.
5. SOLUTION CONTROL LEVER
Controls solution flow to scrub deck.
To increase flow pull and raise the knob to the
desired flow.
To decrease flow push the knob down.
To increase flow pull and raise the knob to the
desired flow.
To decrease flow push the knob down.
6. BATTERY CHARGE LEVEL INDICATOR
Indicates the charge level of the batteries.
The meter display is divided into 10 vertical
bars. Bars illuminated on the far right indicate
full charge. Bars flashing near the left side
indicate the batteries should be recharged.
Further operation of the machine could
damage the machine or the batteries.
When the machine is left overnight with less
than a full charge, the display may initially
indicate a full charge. It will also indicate a full
charge if the batteries are disconnected, then
reconnected. After a few minutes of operation
the meter will give the correct charge level.
The meter display is divided into 10 vertical
bars. Bars illuminated on the far right indicate
full charge. Bars flashing near the left side
indicate the batteries should be recharged.
Further operation of the machine could
damage the machine or the batteries.
When the machine is left overnight with less
than a full charge, the display may initially
indicate a full charge. It will also indicate a full
charge if the batteries are disconnected, then
reconnected. After a few minutes of operation
the meter will give the correct charge level.
7. HOUR METER (OPTIONAL)
Records the number of hours the machine’s
brush has been in operation. This information
is useful in determining when to service the
machine.
brush has been in operation. This information
is useful in determining when to service the
machine.
8. CIRCUIT
BREAKERS
Circuit breakers interrupt the flow of power in
he event of an electrical overload. When a
circuit breaker is tripped, reset it by pressing
the exposed button. If a circuit breaker
continues to trip, the cause of the electrical
overload should be found and corrected.
he event of an electrical overload. When a
circuit breaker is tripped, reset it by pressing
the exposed button. If a circuit breaker
continues to trip, the cause of the electrical
overload should be found and corrected.
30 Amp. Protects the scrub brush
motor.
30 Amp. Protects the vacuum
motor.
motor.
30 Amp. Protects the vacuum
motor.