Monessen Hearth BTU/Hr Benutzerhandbuch

49D0090

PRODUCT IDENTIFICATION

AND

ASSEMBLY

Figure 1 - Vent-Free Gas Log Space Heater

SAFETY DEVICE
This heater has a pilot with an Oxygen Depletion Sensing
(ODS) safety shutoff system. The ODS/pilot is a required
feature for vent-free room heaters. The ODS/pilot shuts
off the heater if there is not enough fresh air.

PIEZO IGNITION SYSTEM
This heater has a piezo ignitor. This system requires no
matches, batteries, or other sources to light heater.

THERMOSTAT HEAT CONTROL
This heater has a thermostat sensing bulb and a control
valve. This results in the greatest heater comfort. This
can also result in lower gas bills.

NOTE: Do not remove Lighting and Warning
Plates from heater.

UNPACKING

1. Remove heater from carton.
2. Remove all protective packaging applied to heater

for shipment.

3. Make sure your heater includes the following:
trim

hood

mounting bracket
hardware package which includes:

two (2) 90° angled brackets and shims

four (4) trim screws

three (3) hood screws

two (2) wall mounting screws

two (2) wall spacers

4. Check heater for any shipping damage. If heater is

damaged, promptly inform dealer where you bought
heater.

ASSEMBLY
INSTALLING HOOD

1. Remove hood from protective package.
2. Locate three (3) black sheet metal screws inside home-

owner’s manual pack.

3. Place hood on deflector and line up holes (see Figure 2).
4. Secure hood to deflector with three (3) black sheet metal

screws.

NOTE: Side of hood should be on the outside flange
of deflector.

Figure 2 - Installing Hood

Hood

Screws

Hood

Control

Knob

Screen

Piezo

Ignitor

Door

Optional Blower

On/Off Switch

Deflector