Sony PDW-70MD Benutzerhandbuch

23

Removing the Connector Covers

  Cha

p

te

r 2  

P

repa

ra

ti

ons

Be sure to carry out step 3 before powering the unit 
off. The new system frequency setting will not be 
saved if you power off without carrying out step 3.

Press the on/standby switch to put the unit into 
standby, and then press it again to power the unit on.

The selected system frequency becomes available for 
use.

You can change the system frequency setting by using the 
setup menu item OPERATIONAL FUNCTION >SYSTEM 
SEL >SYSTEM FREQ. 
For details about the setup menu, see page 67 “System 
Menu” in Chapter 6.

When the unit is shipped from the factory, connector 
covers are attached to the following connectors.
• AUDIO OUTPUT 1/3 and 2/4 connectors 
• HDSDI INPUT connector
• HDSDI OUTPUT connectors 
• SDSDI OUTPUT connector 
• RS232C connector

To use one of these connectors, remove the cover as 
follows.

Press the POWER (main power) switch to power the 

unit off.

Remove the screw(s) of the connector cover, using a 
screwdriver that matches the grooves of the screw(s).

Remove the connector cover.

Save the screw(s) and cover, so that you can reattach 
the cover if necessary.

-