Viking KK823 Benutzerhandbuch

SECTION  TSM 845

ISSUE

F

PAGE  7 OF  14

4.  Insert a brass bar through a port between two rotor teeth 

and loosen the capscrew holding the inner magnet to 

the shaft 

(See Figure 11). Do not forget, this is a very 

strong magnet  If pump disassembly is required, remove 

the external retaining ring 

5.  Do not remove the O-ring unless it is bad, especially 

if  PTFE (Derivative) encapsulated  If a new O-ring is 

required, follow instructions in the 

3.  Support pump with hoist and remove the (4)  5” capscrews  

See Figure 9. Pull the pump out of the bracket; there will 

be some resistance to pull apart since the inner magnet 

assembly will be attracted to the coupling bracket  If 

further disassembly of the bearing carrier is required, 

refer to page 7. Since there will be some liquid left in 

the canister, be aware that liquid will run out when the 

canister separates from the pump   Remove canister if it 

has not already come off the pump