Technicolor - Thomson DCD-SA1 Benutzerhandbuch
ENGLISH
10
4 REMOTE CONTROL UNIT
2
The DCD-SA1 can be controlled from a distance using the included remote control unit (RC-997).
(1) Inserting Batteries
q Remove the remote control unit’s rear cover.
w Place 2 R03/AAA batteries in the battery compartment in the
direction indicated by the marks.
e Close the rear cover.
Cautions on Batteries
• Use R03/AAA batteries in this remote control unit.
• Replace the batteries with new ones approximately once a
• Use R03/AAA batteries in this remote control unit.
• Replace the batteries with new ones approximately once a
year, though this depends on the frequency with which the
remote control unit is used.
remote control unit is used.
• If the remote control unit does not operate from close to the
main unit, replace the batteries with new ones, even if less
than a year has passed.
than a year has passed.
• The included batteries are only for verifying operation.
Replace it with a new battery as soon as possible.
• When inserting the batteries, be careful to do so in the
proper direction, following the < and > marks in the remote
control unit’s battery compartment.
control unit’s battery compartment.
• To prevent damage or battery fluid leakage:
• Do not use a new battery with an old one.
• Do not use two different types of batteries.
• Do not short-circuit, disassemble, heat or dispose of
• Do not use two different types of batteries.
• Do not short-circuit, disassemble, heat or dispose of
batteries in flames.
• Remove the batteries when not planning to use the remote
control unit for a long period of time.
• If the batteries should leak, carefully wipe off the fluid from
the inside of the battery compartment, then insert new
batteries.
batteries.
(2) Using the Remote Control Unit
• When operating the remote control unit, point it at the remote
control sensor as shown in the figure.
• The remote control unit can be used from a direct distance of
approximately 8 meters. This distance will be shorter, however, if
there are obstacles in the way or if the remote control unit is not
pointed directly at the remote control sensor.
there are obstacles in the way or if the remote control unit is not
pointed directly at the remote control sensor.
• The remote control unit can be operated at a horizontal angle of up
to 30° with respect to the remote control sensor.
NOTES:
• It may be difficult to operate the remote control unit if the
• It may be difficult to operate the remote control unit if the
remote control sensor is exposed to direct sunlight or strong
artificial light.
artificial light.
• Do not press the buttons on the main unit and on the remote
control unit at the same time. Doing so will result in
malfunction.
malfunction.
Approx. 8 meters
30°
30°