Dometic 210 Benutzerhandbuch

2

.  Do not use chlorine or caustic chemicals, such as laundry bleach or drain-opening types, 

in the system. These products damage the seals in toilets and dump valves.

2.  Do not permit foreign objects (paper towels, paper cups, diapers, sanitary napkins, etc.) to 

be flushed through the toilet.

3.  Mechanical seal toilets, like SeaLand models, are designed to only discharge directly into 

a holding tank. Horizontal pipe runs as found in conventional residential or commercial 

plumbing systems cannot be accommodated.

4.  Toilet bowl must be regularly cleaned and winterized according to “Proper Bowl Cleaning” 

and “Winterizing” procedures on page 4, or your warranty coverage may be voided. 

Important Information ................................ 2

Toilet Model Identification  ......................... 2

How to Use ................................................ 2

Installation ................................................. 3

Proper Bowl Cleaning  ............................... 4

Winterizing  ................................................ 4

Deodorants and Special Tissue  ................ 5

Troubleshooting  ................................... 6 - 7

Warranty  ................................................... 8

To prepare the SeaLand toilet for use, check to be sure water supply to the toilet is  

connected.  Turn on water supply and check system for leaks. Flush toilet and check for leaks.
To properly use the SeaLand toilet, follow these simple instructions:
. 

To add water to the toilet, lift or raise the flush lever until desired water level is reached.   

Generally, more water is required only when flushing solids.

2. 

To flush toilet, push lever all the way down until contents leave toilet bowl.  Water flow 

pressures vary at different locations, therefore holding the flush lever down for 4-8  

seconds may be required.  We require a minimum flow at the toilet of two gpm (7.6 lpm) 

for proper rim and bowl wash.

3.  Release flush lever by allowing it to snap back, which permits positive sealing around the 

flush ball.

4.  A small amount of water should remain in bowl.
Note:  Holding flush lever down longer than necessary results in excessive water usage.

The model identification label is located on the 

toilet base and will show the model number 

and serial number.  For model 20 toilet, 

remove base cover to locate identification label 

(see page 3).