Dometic 210 Benutzerhandbuch

3

.  To replace an older toilet, turn off water supply to toilet.   

Disconnect water line at toilet water valve. Unscrew floor 

bolt nuts and remove toilet. Discard old floor seal and 

mounting bolts. The old floor flange may be used if it is  

in good condition and fastener holes are positioned as 

shown in Figure A. Make sure center of floor flange is at 

least  inches from back wall (Figure A).

2.  If installing new floor flange, make certain that the toilet 

mounting bolts align properly with SeaLand toilet mount-

ing pattern (Figure B).

3.  Secure flange to floor using at least four flat-head screws 

(one each at the front, back, right and left sides of flange) 

through countersunk holes. Insert floor bolts into slotted 

holes at right and left sides of flange (Figure B).

4.  Position floor seal by pressing the floor bolts up through 

holes in the seal.

5.  Set toilet in place with bolts protruding up through  

mounting holes in base (Figure C).

6.  Install washers and hex nuts provided with toilet.  Snug 

nuts down equally with standard 7/6” open end wrench. 

Install two wood screws provided in two holes at rear of 

base. (Figure C).

7.  If toilet is being installed in a shower stall, apply a /4” 

bead of glazing compound around the perimeter of the 

base (Figure D).

8.  Connect water supply line to water valve (/2” MPT) inlet 

using appropriate fittings or an extension (Figure E). 

9.  Turn on water supply and flush toilet to test for leaks.
10. Attach pedal cover to flush pedal (see instructions below) 

after making sure there are no leaks at connections.

. FOR MODEL 20 ONLY, put base cover in front of toilet 

base, aligning flush pedal with opening on side of cover. 

Push base cover back until it locks into place, making 

sure it does not interfere with flush pedal operation  

(Figure F).

Fig. D

Fig. B

Fig. C

Fig. E

Fig. F

.  Align cover with pedal and press into place so 

that tab locks into space at rear of pedal.

2.  To release cover, 

press on tab at back 

of pedal and pull 

cover off.

Fig. A