Kenwood KRF-V6300D Benutzerhandbuch
38
KRF-V6300D
Recording mode setting in digital
audio source recording
audio source recording
¶ Operation available only on the main unit.
When recording a multi-channel digital audio source, it is
recommended to set up the recording mode properly to convert
the digital input into the 2-channel analog output. Usually use
the "A-REC" (Auto record) mode.
However, some discs often produce sound skipping. The "M-REC"
(Manual record) mode should be used with such a disc.
recommended to set up the recording mode properly to convert
the digital input into the 2-channel analog output. Usually use
the "A-REC" (Auto record) mode.
However, some discs often produce sound skipping. The "M-REC"
(Manual record) mode should be used with such a disc.
INPUT SELECTOR
AUTO/MONO
œ Use [INPUT SELECTOR] to select the source (CD/
DVD, DVD/6CH or VIDEO2) you want to record.
∑ Set the MD or TAPE recorder to record.
é Press and hold [AUTO/MONO] for more than 2
seconds to select a recording mode during digital
input.
input.
Recording mode
Display
Operation
Recording mode off
---
The digital input record mode is switched
off.
off.
Auto record mode
"A-REC"
The digital input signals (DTS, Dolby Digital
or PCM) are identified automatically and
converted into stereo signals that are ready
for recording.
or PCM) are identified automatically and
converted into stereo signals that are ready
for recording.
Manual record mode
"M-REC"
The digital input signal type at the moment
this mode is selected is held throughout
this mode, and the signal is converted into
stereo signals. But once the digital signal is
changed to other signal, no signal is output.
this mode is selected is held throughout
this mode, and the signal is converted into
stereo signals. But once the digital signal is
changed to other signal, no signal is output.
When the "A-REC" mode is selected, the digital input
signal is converted to stereo signals even if the digital
signal is changed.
When the digital mode changes during recording
in the "A-REC" mode, the audio input source may be
interrupted momentarily.
signal is converted to stereo signals even if the digital
signal is changed.
When the digital mode changes during recording
in the "A-REC" mode, the audio input source may be
interrupted momentarily.
For "A-REC" mode:
Recording
For "M-REC" mode:
® Start playback, then start recording.
If the audio reproduction stops in the middle due to
change in the input signals, etc., press [AUTO/MONO].
change in the input signals, etc., press [AUTO/MONO].
Recording audio (analog sources)
œ Use [INPUT SELECTOR] to select the source (other
than "MD/TAPE") you want to record.
∑ Set the MD or TAPE recorder to record.
é Start playback, then start recording.
Recording video
œ Use [INPUT SELECTOR] to select the video source
(other than "VIDEO1") you want to record.
∑ Set the video deck connected to VIDEO 1 to record.
Select the REC MODE to record a digital input source.
See <Recording mode setting in digital audio source
recording>.
See <Recording mode setting in digital audio source
recording>.
é Start playback, then start recording.
Recording may not be normal for some video software.
This is due to the copy guard condition.
This is due to the copy guard condition.
B60-5772-00_00_EN.indd 38
B60-5772-00_00_EN.indd 38
08.7.24 1:29:48 PM
08.7.24 1:29:48 PM