Roland VS-20 Benutzerhandbuch

Seite von 52
40
Troubleshooting
Problems with Recording
Problem
Points to check
Action
Can’t record
Could a message be indicating 
“Unable to open audio record 
device”?
If Media Player or another application that has audio playback capability is running, 
Guitar Tracks 4 won’t be able to use the audio driver, and an error appears when Guitar 
Tracks 4 is started. Close the audio playback application, and then start Guitar Tracks 4 
again.
If an audio driver not being used by Guitar Tracks 4 is installed, try either disabling that 
driver or disconnecting the corresponding audio interface from your computer. 
 
Dropouts occur in the 
recording
Could you have connected/
disconnected another USB device, 
such as a memory key?
Dropouts may occur during playback or recording if you connect/disconnect another 
USB device (such as a memory key), or switch a device’s power on/off at the same time 
that the V-STUDIO 20 is being used.
Are you using a hard disk that is 
connected via USB?
Data transfer using USB could get congested if you use the V-STUDIO 20 and a USB-
connected hard disk at the same time. As a result, the data transfer speed for the hard 
disk could be significantly reduced. As a storage location for the audio data that you 
record and play back, you should avoid using a hard disk that is connected via USB.
Did the dropout occur immediately 
after the system started up, or after 
it woke from sleep?
Dropouts during playback/recording sometimes occur immediately after the system 
has started up, or after it has woken from sleep. Wait for a while, then try the playback/
recording again.
Recording Halts Midway, 
and Subsequent 
Recording is Not Possible
While you were using the 
V-STUDIO 20, could your computer 
have performed a task with a heavy 
processing load, such as accessing 
a DVD-ROM drive or the network?
If a heavy processing load occurs while the V-STUDIO 20 is being used, it may not work 
correctly. In this case, stop playback, and then start playback once again.
 
If you are still unable to play, close all software that was using the V-STUDIO 20, 
disconnect the USB cable from the V-STUDIO 20 hardware, and then reconnect it.
Guitar Sound is Not Loud 
Enough
Are you using the correct 
connector?
Connect your guitar to the GUITAR/BASS jack.
Could you be using a connection 
cable that contains a resistor?
Use a connection cable that does not contain a resistor.
Microphone is Not Loud 
Enough
Are you using the correct 
connector?
Connect your microphone to the MIC 2 jack (XLR type jack).
Is the input level set appropriately?
Adjust the input level. (p. 29)
Could you be using a connection 
cable that contains a resistor?
Use a connection cable that does not contain a resistor.
VS-20_e.book  40 ページ  2010年1月18日 月曜日 午前9時8分