Pelco C2458M-E Benutzerhandbuch
6
C2458M-E (10/06)
Windows-Based PC Installation and Operation
To interface with a Spectra dome drive or IPS-RDPE-2 remote data port using a Windows-based PC,
first install the control/upload utility and then install the IPS-CABLE.
first install the control/upload utility and then install the IPS-CABLE.
The control/upload utility is compatible with the following operating systems:
Windows
®
95
Windows 98
Windows ME
Windows 2000
Windows XP
Windows NT
Windows ME
Windows 2000
Windows XP
Windows NT
®
with service pack 6
NOTE: Know how to operate a Windows-based PC before attempting to control or upload software
using the interface cable (IPS-CABLE).
using the interface cable (IPS-CABLE).
INSTALL THE CONTROL UTILITY FOR WINDOWS
1. Insert the Resource CD into the CD drive. The main menu appears on the monitor.
NOTE: If autoplay is not enabled on your system, you need to navigate to the CD drive and select
Start to open the main menu.
Start to open the main menu.
2. Click the Control/Upload Utility button for Spectra, Esprit, or ExSite. The Install Shield Wizard
starts.
3. Follow the instructions displayed on the monitor.
INSTALL THE CABLE
To install the IPS-cable, refer to Figure 1 and do the following:
1. Connect a null modem cable (not supplied) to the COM1 or COM2 serial port on the PC.
2. Connect the 9-pin male connector from the IPS-CABLE to the null modem cable.
3. Connect the IPS-CABLE to the RJ-45 port of the Spectra dome drive or IPS-RDPE-2.
NOTE: When connected, the IPS-CABLE will interrupt control from the normal control source.